Lighting is usually the largest single electrical load in a commercial building and the one with the clearest payback on upgrading. An LED retrofit cuts consumption substantially, cuts the relamping labour that nobody budgets for, and generally improves light levels at the same time.
We install and maintain indoor and outdoor LED lighting for retail, office, restaurant, warehouse, and light industrial properties across Polk County, along with parking lot lighting maintenance, emergency and exit lighting, and automated lighting controls.
Parking lot and site lighting deserves particular attention. It is a liability question before it is an aesthetic one. Dark corners in a lot are where slip-and-fall and security incidents happen, and a pole that has been out for three months is exactly what a plaintiff attorney will photograph.
Many customers pair commercial lighting with commercial electrical and lighting installation. Not sure where to start? Read signs you need an electrical panel upgrade in Polk County.
Serving Polk County: Lake Wales, Winter Haven, Bartow, Haines City, Lakeland, Dundee, Frostproof, Auburndale, Polk City, Davenport, Fort Meade, Lake Alfred, and the surrounding Central Florida communities. Call (863) 676-0198 to book.
“Kincaid did an excellent job adding outlets to my garage apartment. Their final fee matched their quote and they cleaned up and it was like they were never there!! (Except for the new outlets) Can’t stress enough the value of an honest electrician!”
What We Cover
Interior
- LED troffer and panel retrofits
- High-bay and warehouse lighting
- Retail display and accent lighting
- Emergency and exit lighting, testing and replacement
Exterior And Site
- Parking lot pole lighting installation and maintenance
- Wall packs and building perimeter lighting
- Canopy and drive-through lighting
- Signage and monument lighting circuits
Controls
- Occupancy and vacancy sensing
- Daylight harvesting
- Photocell and astronomic timeclock control
- Automated and zoned lighting control systems
What To Look For In A Commercial Lighting Contractor In Lakeland, FL
A commercial lighting contractor in Lakeland, FL should be able to do more than swap lamps. The job usually touches the circuit, the controls, and the panel feeding it. A good contractor counts fixtures, checks what is actually wired in the ceiling, and tells you if a circuit is overloaded or a switch leg is wired in a way that will not accept the new equipment. Those details are easy to confirm on a walkthrough and hard to fix once the work is finished.
Ask who does the work and who answers for it afterward. Lighting in occupied stores, offices, and restaurants has to be installed around business hours, with clean wiring and clear labeling left behind. We are licensed electricians, so a failed driver, a bad connection, or a dead circuit gets fixed on the same visit instead of being handed to a second company. A short written scope after the visit makes clear what is included and what is a separate item.
Planning New Parking Lot Light Installation For A Winter Haven, FL Property
Parking lot light installation for a Winter Haven, FL property starts with what is already in the ground. Existing poles, bases, and conduit make the job far simpler. A bare lot needs trenching, foundations, and a feed from a panel with spare capacity. We walk the site and mark pole positions so the light overlaps and no dark pocket is left between fixtures. We also plan the evening check, since a quick look once the lot is energized confirms every pole is lit and the coverage is even.
Fixture choice matters as much as pole count. Mounting height, the light distribution pattern, and shielding all decide where the light lands. Spill onto a neighbor is a common complaint, and glare at an entrance is a safety problem of its own. We also plan the control side, either a photocell or a timeclock, so the lot switches on and off without anyone walking out to a breaker. The plan then goes to you in writing, so the lighting layout and the price match before anything is ordered.
Parking Lot Light Pole Repair: Find The Real Fault Before Replacing Anything
Parking lot light pole repair begins with a short list of causes. A single dark pole is often a bad photocell, a failed driver, a loose splice in the handhole, or a tripped breaker. Several poles out together usually point to a shared circuit, a failed contactor, or a damaged underground run. Replacing a fixture before testing the circuit is the quickest way to pay twice. Checking the circuit first rules out causes in order, so you do not pay for parts the problem never needed.
Poles outdoors in Florida take rain, heat, and irrigation overspray, and the base is where moisture does the damage. We open the handhole, check for corrosion and water, test voltage at the pole, and confirm grounding. Damaged or leaning poles from vehicle strikes are a safety matter too, and we tell you plainly when the pole itself needs a different contractor. We report what we find at the base and the handhole, so you can see why a repair or a replacement is the right call.
Warehouse LED Lighting Installation: Layout, Mounting Height, And Controls
Warehouse LED lighting installation is mostly a layout problem. High-bay fixtures hung at twenty feet or more need to light the aisles and the racking faces, not just the floor. Rack height, aisle width, and the work done in each area decide fixture spacing and light output. A dimmer fixture over a packing table and a brighter one over a loading dock is normal. We count the fixtures, note the mounting heights, and confirm the existing circuits, so the plan matches the real building.
Working height changes the labor, because lifts and safe access drive the schedule. We plan the circuits so a section can be switched off without darkening the whole building, and we add occupancy sensors in low-traffic aisles. Old metal halide and fluorescent fixtures get disconnected and removed cleanly, with their circuits checked first so the new drivers are not fed from a tired old run. Good access planning keeps the work from disrupting forklifts and staff, and each section is tested before we move on.
LED Lighting Retrofit For A Business In Florida: Where The Savings Come From
An LED lighting retrofit for a business in Florida pays back in a few places at once. Power use drops, the lamps last far longer, and the heat the fixtures dump into the room goes down, which helps the air conditioning. The maintenance saving is real too, since fewer burned-out tubes means fewer ladder calls and fewer dark spots in a customer-facing space. We compare options by running hours and upkeep, which is more honest than comparing the fixture price alone.
Whether you swap only the lamps or replace the whole fixture depends on what is overhead. Some old housings take a retrofit kit well. Others have failing sockets or ballasts, and the cleaner answer is a new fixture. We inspect a sample before recommending either, so you are not paying for a full replacement where a retrofit works, or the reverse. We can also check whether a utility rebate program applies before you commit to the work.
Ready to book commercial lighting?
Licensed, family owned, and working out of Lake Wales since 1973. Upfront pricing, and a real person on the phone.
Other Commercial Services
Commercial Lighting Across Polk County
The same crew covers the whole service area. Pick your city for local detail, or just call us.
Lake Wales/Winter Haven/Bartow/Haines City/Lakeland/Dundee/Frostproof/Auburndale/Polk City/Davenport/Fort Meade/Lake Alfred
Commercial Lighting FAQs
Is an LED retrofit worth it for our building?
Almost always, and the payback is usually faster than owners expect once you count the relamping labour you stop paying for. We can walk the building, count fixtures and run hours, and give you a realistic picture rather than a sales number.
Can you maintain our parking lot lighting on a schedule?
Yes, and we recommend it. Scheduled maintenance catches outages before a tenant or an insurer does, and group relamping is far cheaper per fixture than sending a bucket truck out one pole at a time.
Do you handle emergency and exit lighting testing?
Yes. Emergency and exit lighting needs periodic testing to stay compliant, and it is one of the first things a fire inspector checks. We test, replace failed units and batteries, and document it.
Can you install lighting controls to cut our usage further?
Yes. Occupancy sensing, daylight harvesting, and timeclock control typically add meaningful savings on top of an LED retrofit, particularly in offices and warehouses where lights run in empty spaces.
How much does it cost to install parking lot lighting?
The cost is set by pole count and height, whether foundations and conduit already exist or the lot has to be trenched and poured, the fixture wattage and photometric requirement, and whether the service has capacity for the added load. Reusing existing poles and bases is dramatically cheaper than a new install. Published national guides show wide ranges per pole and per project, and those are general market figures rather than a Kincaid quote. We survey the lot and price it properly.
How much does commercial LED lighting retrofit cost per fixture?
It depends on what is being retrofitted. A lamp and driver retrofit inside an existing housing sits at the low end. A full fixture replacement costs more, and a high-bay conversion in a warehouse costs more again because of the working height and the equipment needed to reach it. Adding controls, mounting height, and ceiling access all move the number. Published national ranges exist per fixture type, but we count your fixtures and quote from that.
What is the average cost of a solar parking lot light?
Solar poles cost considerably more per pole than a mains-fed fixture, but they avoid trenching, conduit, and the service capacity question entirely, which is where the savings sit on a lot with no existing infrastructure. Battery replacement every few years is a running cost to plan for, and Florida cloud cover and tree shading affect real performance more than the datasheet suggests. We will tell you honestly whether your lot is a good candidate before quoting either approach.
How many lumens do I need for a parking lot?
Lumens on their own are the wrong measure. What matters is the illuminance at the surface, measured in foot-candles, and how evenly it is distributed, because a bright pool next to a dark gap is worse for liability than a lower uniform level. General guidance for a standard commercial lot is roughly one to two foot-candles average with attention to uniformity, and entrances and pedestrian crossings want more. We run a photometric layout rather than guessing at fixture wattage.
How long does an LED retrofit take to pay for itself?
For a building whose lights run long hours, meaning warehouses, twenty-four hour operations, and parking lots, the payback is usually measured in a small number of years, and the maintenance labour you stop paying for is often half of it. For a space lit eight hours a day it takes longer. Utility rebates through Lakeland Electric or Duke Energy Florida shorten it where they apply. We count fixtures and run hours and give you a realistic figure rather than a sales number.